Stryker Sr 497Hpc Settings (2024)

FAQs

Does a Stryker 497 have a SWR meter? ›

Press the PTT (Press-To-Talk) switch, and tap the antenna (making it shorter). The SWR meter will show a lower reading each time the antenna is tapped. By continuing to shorten the antenna, you will notice the SWR reading will reach a low point and then start rising again.

The SR-497HPC dimensions are; 2-3/8” (H) x 7-7/8” (W) x 9-1/4” (D).

No tune or programming needed and the power, modulation and reception is unmatched by anything I have ever used. Small compact size will fit into any truck CB mounting location. I'm about to order a 2nd one just to put in the closet in case they decide to stop making these.

This function lets you choose from a total of 8 roger beep. the RB tones are programmable REP setting is choose offset direction + or - or OFF. You can programming the offset frequency , default value is 100Khz.

You should see the following numbers on the SWR line of your meter: 1, a space for 1.5, 2, and 3. If your SWR reading is below the 2 mark, your reading is within tolerance. If your SWR reading is below the 1.5 notch, your antenna system is working very well.

Learning how to tune an antenna entails lengthening or shortening the antenna so that, for the radio's specific frequency, it is working as efficiently as possible. In order to tune an antenna, a radio needs to be hooked up to an SWR (standing wave ratio) meter using coaxial cables.

SR-497HPC needs a 25-amp power supply. SR-94HPC should be powered by a 12-amp supply. SR-25MC requires a minimum of 5 amps.

Completely Banned for the Greater Good

This rig is marketed as a "10M Amateur Radio" which raises a red flag right there, that "tuned and aligned" bit means being illegally modified for use on 11M CB.

SWR Range Explanations. SWR 1.0-1.5: The ideal range! If your SWR is under 1.5, you're in great shape. If you're at 1.5 and really, really want to drop down to closer to 1, it's likely possible to do with addition tuning, different equipment or a different mounting location.

What is the difference between Stryker and BTR 60? ›

When it first deployed in 1960, the BTR-60 had a crew of two, could hold 14 passengers, and was armed with a 14.5mm KPV heavy machine gun and a 7.62mm machine gun. The M1126 Stryker, by comparison, has a crew of three, holds nine troops, and carries an M2 heavy machine gun or a Mk 19 automatic grenade launcher.

(W) 6.2 (H) 1.9 (D) 9.7 including protruding parts on depth to include knobs on the front panel. It's the same size as a Cobra 25LTD.

These radios are also referred to as amateur, transmitting and receiving frequencies at a range of 10 meters. They're ideal for long-distance communication. A 10 meter radio transmits waves between 28 and 29.7 MHz (Megahertz.) These are very high frequencies; hence, not anyone can utilize them.

To reset: Re-insert CPR plugs. Screen will automatically reset.

While holding mic button adjust the SWR CAL knob so the meter needle swings to the CAL ▼ mark on the meter (located on the right). The reading will be slightly higher on Channels 1 and 40 compared to Channel 20. When switched to SWR position the meter needle should ideally be as far to the left as possible.